Minimum Clearance To Combustibles - Napoleon Bayfield GDS25N-1 Manuel D'installation

4.8

MINIMUM CLEARANCE TO COMBUSTIBLES

installation
EN
EN
3.8 minimum clearance to combustibles
MINIMUM CLEARANCE TO COMBUSTIBLES MUST BE MAINTAINED OR A SERIOUS FIRE HAZARD
WARNING
!
• Minimum clearance to combustibles must be maintained or a serious fire hazard could result.
FRAMING OR FINISHING MATERIAL CLOSER THAN THE MINIMUMS LISTED MUST BE CONSTRUCTED
• Framing or finishing materials closer than the minimums listed must be constructed entirely of non-com-
ENTIRELY OF NON-COMBUSTIBLE MATERIALS (I.E. STEEL STUDS, CEMENT BOARD, ETC.).
bustible materials (i.e. steel studs, cement board, etc.).
• Never obstruct the front opening of the appliance.
As long as clearance to combustibles is kept within the required distances, the most desirable and beneficial
As long as clearance to combustibles is kept within the required distances, the most desirable and bene cial
location for a Napoleon® appliance is in the centre of a building, thereby allowing the most efficient use of the
location for a Napoleon® appliance is in the centre of a building, thereby allowing the most efcient use of
heat created. The location of windows, doors and the traffic flow in the room where the appliance is to be located
the heat created. The location of windows, doors and the traf c ow in the room where the appliance is to be
should be considered. If possible, you should choose a location where the vent will pass through the house with-
located should be considered. If possible, you should choose a location where the vent will pass through the
out cutting a floor or roof joist.
house without cutting a oor or roof joist.
4" (102mm)
A.
A.
4" (102mm)
To ceiling from appliance top
To ceiling from appliance top
Horizontal vent:
Horizontal vent
Sides and bottom
Sides and bottom
Top
Top
Vertical vent
Vertical vent:
All sides
All sides
*At a distance of 2" (51mm) from the wall, installation or service to the blower may not be practical. A minimum
*At a distance of 2" (51mm) from the wall, installation or service to the blower may not be practical. A minimum of
of 5" (127mm) will be required in order to install the blower.
5" (127mm) will be required in order to install the blower.
If less than 5" (127mm) clearance is maintained between the back of the appliance and the back wall, it will be
If less than 5" (127mm) clearance is maintained between the back of the appliance and the back wall, it will be
necessary to disconnect the venting and gas pipe to move the appliance out for installation or service of the
necessary to disconnect the venting and gas pipe to move the appliance out for installation or service of the
blower.
blower.
W415-1332 / A / 11.21.14
24
W415-2207 / C / 08.23.18
COULD RESULT.
NEVER OBSTRUCT THE FRONT OPENING OF THE APPLIANCE.
2" (51mm)*
B.
B.
2" (51mm)*
48" (1219mm)
48" (1219mm)
1" (25mm)
1" (25mm)
2" (51mm)
2" (51mm)
1" (25mm)
1" (25mm)
WARNING
!
2" (51mm)
C.
C.
2" (51mm)