Table des Matières
Publicité
44
8.0 OPERATION
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT WITH
8.1
GENERAL TRANSMITTER LAYOUT
TRANSMISSION
THERMOSTAT
CHILD SAFETY
OFF/ON/SMART
LOCK OUT
6
TEMPERATURE SET POINT/ LEVEL/ STATUS
FLAME
8.2
APPLIANCE OPERATION
A.
Install 4 AA batteries into the receiver battery bay as indicated on the battery cover (+/-). (Only required
as back up to household electricity).
While there is a provision to connect a 6V battery pack (do not use a 9 volt battery), it must not be
used when using the remote control receiver.
B.
Place the 3 position slider switch of the receiver in the "Remote" position.
C.
Using the end of a paper clip, or other similar object, insert the end of the paper clip into the hole
marked "PRG" on the receiver front cover. The receiver will "beep" three (3) times to indicate that it is
ready to synchronize with the transmitter.
D.
Install the 3 AAA batteries in the transmitter battery bay, located on the base of the transmitter.
With the batteries already installed in the transmitter, push the "ON" button. The receiver will "beep"
four times to indicate the transmitter's command is accepted and set to the particular code of that
transmitter. The system is now initialized.
8.3
HAND HELD REMOTE OPERATIONS
A.
Press the ON/OFF key on the transmitter. The transmitter
display will show all active icons on the screen. A single
"beep" from the receiver will confi rm reception of the
command.
W415-0745 / E / 08.15.12
CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
THE GLASS DOOR OPENED OR REMOVED.
NOTE: The remote system is equipped to control a fan but this feature
is not available with the LHD50.
ROOM
LOW BATTERY
ALARM
TEMPERATURE
FAN
AUX. OUTPUT
35.1
WARNING
!
35.3
BLUE LCD DISPLAY
ON/OFF KEY
THERMOSTAT KEY
UP/DOWN
ARROW KEY
MODE KEY
35.4
Publicité
Table des Matières
