Switch Functions; Logo Placement - Napoleon Bayfield GDS25N-1 Manuel D'installation

B. Place the hole in the underside of log #2
finishing
onto the locating screw, on the left side of the
EN
burner. The bre burner is formed to cradle
the centre of the log.

5.5.1 SWITCH FUNCTIONS

B. Place the hole in the underside of log #2
onto the locating screw, on the left side of the
burner. The fibre burner is formed to cradle the
centre of the log.
5.6

LOGO PLACEMENT

4.5 logo placement
Remove the backing from the logo and position onto the control door as shown.
Remove the backing from the logo and position onto the control door as shown.
W415-1332 / A / 11.21.14
28
W415-2207 / C / 08.23.18
C.
D.
MAIN
BURNER
SWITCH
FAN
CONTROL
C.
D.
1/2"
LOGO
1/2"
Place the hole in the underside of log #3 onto
the locating screw, on the right side of the
burner. The bottom branch of log #3 sits in
front of, and against, the right end of log #2.
Reinstall the glass door & front.
ACCENT
LIGHT
SWITCH
Place the hole in the underside of log #3 onto
the locating screw, on the right side of the
burner. The bottom branch of log #3 sits in
front of, and against, the right end of log #2.
Reinstall the glass door & front.