3.0 remote control layout
remote control layout
EN
3.1
general transmitter layout
note:
The remote control is optional for the BL36-1 and BL46 models.
Transmission
Flame ON
3.2
initializing the transmitter / battery holder for the fi rst time
A.
Install the 4 AA batteries into the Profl ame 2 battery holder, note the polarity of the batteries and insert as
indicated on the cover (+/-).
B.
Ensure the 3 position slider switch is switched to the "REMOTE" position (middle position).
C.
Press the reset/programming button, use a small object such as a paper clip in order to reach the button
marked PRG, as shown in the illustration below.
D.
The battery holder will beep 3 times to indicate that it's ready to synchronize with the transmitter.
E.
Install the 3 AAA batteries into the transmitter, as shown in the photograph below, then press the ON
button, The battery holder will beep 4 times to indicate that the transmitter's command is accepted.
note:
The initializing process must be completed within 10 seconds of pressing the reset/program button (PRG).
BATTERY HOLDER
SLIDER SWITCH
RESET/PROGRAM
BUTTON (PRG)
3.3
temperature display
A. With the system in the off position, press the temperature key
and the mode key at the same time to change from degrees ºF to
ºC.
B. Look at the LCD screen on the transmitter to verify that a ºC or ºF
is visible to the right of the room temperature display.
12
W415-2759 / C / 11.05.20
Blower
Key Lock
Low battery alarm
Room
Temperature
CPI mode
Light
TRANSMITTER
°F
73
°C
23