Removing Propeller; Installing Propeller - Yamaha Motor F175 Manuel De L'utilisateur

Maintenance
1. Propeller shaft
EMU42632

Removing propeller

1. Straighten the cotter pin and pull it out
using a pair of pliers.
2. Remove the propeller nut, washer, and
spacer. WARNING! Do not use your
hand to hold the propeller when loos-
ening the propeller nut.
1. Cotter pin
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Thrust washer
3. Remove the
equipped), and thrust washer.
90
1
ZMU07855
[EWM01891]
6
5
4 3
2
ZMU07843
propeller, spacer
EMU41981

Installing propeller

EWM00771
WARNING
On counter rotation models, be sure to
use a propeller intended for counterclock-
wise rotation. These propellers are identi-
fied with the letter "L" after the size
indication on the propeller. Otherwise the
boat could move in the opposite direction
from that expected.
ECM00502
NOTICE
Make sure to use a new cotter pin and
bend the ends over securely. Otherwise,
the propeller could come off during oper-
ation and be lost.
1. Apply Yamalube Marine Grease to the
propeller shaft.
2. Install the thrust washer and propeller on
the propeller shaft. NOTICE: Make sure
to install the thrust washer before in-
stalling the propeller. Otherwise, the
lower case and propeller boss could
be damaged.
3. Install the spacer, washer, and propeller
1
nut. Tighten the propeller nut to the
specified torque.
(if
[ECM01882]