Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DRIVE CONFIGURATION
Motor Type Selection
DRIVE CONFIGURATION
To adjust system settings, make sure power is off and remove the cover.
MAX AMPS
1/2
3/4
1
1.5
1
2
3
4
SW1
Contact with hazardous voltage could result in death or serious injury.
•
Do not attempt to modify DIP switch or potentiometer settings until power has been removed and 5
minutes have passed to allow internal voltage to discharge.
•
Do not power on or use the drive with the cover removed.
Motor Type Selection
Select Motor Type (DIP SW1 – Position 6)
When using a Franklin Electric Submersible motor, SW1 – Position 6 must be set to SUB (down).
When using a Surface/Centrifugal style pump, SW1 – Position 6 must be in the CEN (up) position.
Select Submersible Motor Phase (DIP SW1 – Position 7)
When using a Single phase 3-wire submersible motor, position 7 must be set to MD 3W (up).
When using a Three phase submersible motor, position 7 must be set to SD 3P (down).
Submersible Motor Horsepower Setting (DIP SW1 – Positions 1–5)
Select a single DIP switch from SW1, position 1 - 5 that corresponds with the submersible motor/pump HP
being used and place it in the U
on the shield.
Selecting none or more than one switch will result in an Invalid Configuration fault.
Surface Pump Maximum Amps Setting (DIP SW1 – Positions 1–5)
When the drive is configured to operate a surface style pump, SW1 – Positions 1-5 must be used to set the
correct MAX AMPS motor overload current to properly protect the motor. Refer to
Positions 1–5)" on page 23
NOTE: DIP SW1 – Position 8 is not used at this time.
22
FAST
MED
MD
RÁPIDO
MEDIO
2
CEN
3W
XDCR
VITE
MOYEN
5
6
7
8
1
2
3
SUB
SD
PS
3P
position. The corresponding HP values are printed above the SW1 diagram
P
for more information.
SLOW
LENTO
FW
LENT
DD
VER
SF
BP
4
5
6
7
8
1
2
SW2
"Maximum Amps (DIP SW1 –
LT
AB
BD
HZ
3
4
5
6
7
8
ST
SW3
+
-
Publicité
Chapitres
Table des Matières
Dépannage
