Installation Planning; Planning Considerations - Franklin Electric SUBDRIVE UTILITY UT3P Manuel Du Propriétaire

INSTALLATION PLANNING

Planning Considerations

INSTALLATION PLANNING
Planning Considerations
Refer to the following table when planning installation of the drive.
1
Plan System Goals Identify
Options
Intended Function Automation
• Constant • Bump mode
pressure water • System response
systems
• Pressure • Steady Flow
Boosting • Drawdown
Hardware
Application
• Submersible or
Surface pump
• Single Phase
(3W) or Three
Phase (3P)
1. The planned usage of the overall system will determine which options and control methods are appro-
priate, as well as how the drive should be installed and programmed. Refer to the following pages for
examples of how the system might be used.
2. System options define and automate features that support the intended operation. These features may
require specialized control methods and programming. For more details, refer to
on page 22, and "Performance Settings" on page
3. The drive supports several methods for automating pump motor speed control. Refer to
uration" on page 22
4. The overall function of the system directly affects where and how the drive should be mounted. Refer
to "Physical Installation" on page 14
5. The selected motor application, along with the control method(s), determines how the drive should be
connected. Refer to
6. The drive can be quickly and easily programmed for most standard operations. Refer to
uration" on page 22. Advanced features or options may require additional adjustments to achieve the
desired performance. Refer to
10
2
Select Control
Methods
Pressure Feedback
Type
• Pressure Sensor
• Transducer
speed
Adjustable
• Setpoint value for
transducer
• Underload
Sensitivity
for possible control setups.
for guidelines.
"Electrical Installation" on page 16
"Performance Settings" on page
3 4
Install drive Hard-
ware
Location
• Inside
• Outside
Climate control
• Temperature
• Moisture
Distance
• Wire sizes
• Filtering
requirements
Measurements
• Clearance
• Drilling
25.
for more information.
25.
5
Install Wiring Program
Parameters
Conduit Basic
• Routing • Application
• Separation • Motor ratings
High Voltage • Setpoints
• Grounding
I/O setup
• Inputs • Sensor Type
• Outputs Option settings
• Enable features
Control circuits
• Feedback inputs
"Drive Configuration"
"Drive Config-
"Drive Config-
6