Electrical Installation; Wiring Guidelines; Cable Routing - Franklin Electric SUBDRIVE UTILITY UT3P Manuel Du Propriétaire

ELECTRICAL INSTALLATION

Wiring Guidelines

ELECTRICAL INSTALLATION
Wiring Guidelines
Follow the recommendations in this section to ensure best performance of the drive and to avoid interfer-
ence with other devices.

Cable Routing

Use the above diagram as a guide when routing wiring to the drive.
1. Mount the drive as close as possible to the service entrance panel. Wire directly to the service entrance.
Do not connect to a sub-panel.
2. Use a dedicated branch circuit for the drive. Refer to
3. Route motor wiring out of building as soon as possible. Separate input power and motor wiring by at
least 8 in. (20.3 cm). Refer to
4. Cross over other branch circuits and facility wiring at a 90 angle. If it is necessary to run wiring in
parallel, separate by at least 8 in. (20.3 cm).
All control wiring — switches or transducers — should be in a separate conduit routed individually, not
parallel, from high voltage wiring. In addition, any shielded cables should be properly grounded.
16
"Fuse/Circuit Breaker and Wire Sizing" on page
"Maximum Motor Cable Length" on page 18.
17.