Operating Your Appliance; Initializing The Transmitter / Battery Holder For The Fi Rst Time; Using Your Appliance - Napoleon Elevation X Serie Manuel Du Propriétaire

2.1 initializing the transmitter / battery holder for the fi rst time
WARNING
!
• Ensure the gas and electrical power to the appliance is turned off.
• Appliance may be hot, do not service until the appliance has cooled.
A.
Install the 4 AA batteries into the Profl ame 2 battery holder, note the polarity of the batteries and insert as
indicated on the cover (+/-).
B.
Ensure the 3 position slider switch is switched to the "REMOTE" position (middle position).
C.
Press the reset/programming button, use a small object such as a paper clip in order to reach the button
marked PRG, as shown in the illustration below.
D.
The battery holder will beep 3 times to indicate that it's ready to synchronize with the transmitter.
E.
Install the 3 AAA batteries into the transmitter, as shown in the photograph below, then press the ON
button. The battery holder will beep 4 times to indicate that the transmitter's command is accepted.
note:
The initializing process must be completed within 10 seconds of pressing the reset/programming button (PRG).
Battery Holder
(including switch)
Slider Switch
Reset / Program
Button (PRG)
2.2

using your appliance

When operating your appliance for the fi rst time, there is a required burn-in process that cures materials used
to manufacture the appliance that may emit both vapors and an odor. These are normal when operating a new
appliance for the fi rst time. Ensure adequate air circulation is provided during burn-in process, if this was not
completed by the installer during installation.
To turn the appliance on:
A Turn the remote on.
B After 3-5 seconds, the control will start a spark at the pilot, light the pilot and then the burner. The spark
period will last 60 seconds, or until the pilot has lit.
C When used for the fi rst time, if the burn-in process was not completed by the installer; run appliance
continuously for minimum 4 hours (burn-in).
D Turn the appliance off. Wait until appliance is completely cool before moving to the next step.
E Remove the safety barrier, door trims and fi rebox glass door. Clean fi rebox glass door (see "maintenance"
section). Replace fi rebox glass door, door trims and safety barrier.
For more detailed information, see your installation manual or contact your authorized dealer.

2.0 operating your appliance

EN
Remote control
7
W415-2001 / 09.27.19