Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.3
Initializing the transmitter/ battery holder for the fi rst time
NOTE: THE INITIALIZING PROCESS MUST BE COMPLETED WITHIN 10 SECONDS OF PRESSING
THE RESET/PROGRAM BUTTON (PRG).
A.
Install the 4 AA batteries into
indicated on the cover (+/-).
B.
Ensure the 3 position slider switch is switched to the "REMOTE" position (middle position).
C.
Press the reset/programming button, use a small object such as a paper clip in order to reach the button
marked PRG, as shown in the illustration below.
D.
The battery holder will beep 3 times to indicate that it's ready to synchronize with the transmitter.
E.
Install the 3 AAA batteries into the transmitter, as shown in the photograph below, then press the ON
button, The battery holder will beep 4 times to indicate that the control board's command is accepted.
BATTERY HOLDER
SLIDER SWITCH
RESET/PROGRAM
BUTTON (PRG)
6.4
temperature display
A. With the system in the off position, press the Temperature Key and the
mode key at the same time to change from degrees F to C.
B. Look at the LCD screen on the transmitter to verify that a C or F is
visible to the right of the Room Temperature display.
6.5
fl ame height time
The remote control has six (6) fl ame levels. With the system on and the fl ame level at the maximum, press the Down
arrow key once and it will reduce the fl ame height by one step until the fl ame is turned off.
The Up Arrow Key will increase the fl ame height each time it is pressed. If the Up arrow key is pressed while the
system is on but the fl ame is off, the fl ame will come on at the high position. A single "beep" will confi rm reception of
the command.
the Profl ame 2
battery holder, note the polarity of the batteries and insert as
76
76
°F
OFF
Flame Off
Flame at level 1
operation
TRANSMITTER
°F
73
76
°F
°F
Flame at level 5
Flame at "Hi" level 6
W415-1673 / A / 10.07.19
EN
°C
23
76
°F
Hi
33
Publicité
Chapitres
Table des Matières
Dépannage
