Removal Of Metal Storage Shelves; Electrical Connection; Design And Function - CASO DESIGN Dry-Aged Cooler 688 Mode D'emploi Original

14.5.1

Removal of metal storage shelves

To remove a metal storage shelf, first remove the meat. Use gloves which are suitable for
contact with food. Lift the shelf upwards and the gently pull it out
► Carefully ensure that the metal storage shelves and/or the metal suspension system for
the meat hooks is correctly locked into position before you place meat on it or suspend
meat from it.

14.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
 The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
 This unit is not designed to be installed in an RV or used with an inverter.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.

15 Design and Function

This chapter provides you with important safety notices on the design and function of the
device.
PLEASE NOTE
36