Instructions For Assembly Of The Loose Parts And Accessories; Deactivation Of Machine; Minimum Requirements For Housing The Machine; Anchoring The Machine - Promac SX-823DGVI Mode D'emploi

If the machine needs to be moved in its own packing, use
a forklift truck or sling it with straps as illustrated in
drawing above.

4.3 Minimum requirements for housing the machine

- Main voltage and frequency must comply with the
machine's motor requirements.
- Environment temperature should fall within –10 ºC to
+50 ºC.
- Relative humidity cannot be over 90%.

4.4 Anchoring the machine

Position the machine on a firm cement floor, maintaining,
at the rear, a minimum distance of 800 mm from the wall;
anchor it to the ground as shown in the diagram, using
screws and expansion plugs or tie rods sunk In cement,
ensuring that it is sitting level.
4.5 Instructions for assembly of the loose parts and
accessories
Fit the components supplied:
Detail 1 Mount bar-stop rod
Detail 2 Mount and align the roll-supporting arm as per the
counter-vise table.

4.6 Deactivation of machine

- If the sawing machine is to be out of use for a long period, it
is advisable to proceed as follows:
1) Detach the plug from the electric supply panel
2) Loosen blade
3) Release the arch return spring
4) Empty the coolant tank
5) Carefully clean and grease the machine
6) If necessary, cover the machine.
4.7 Dismantling (due to deterioration and/or obsolescence)
General rules
If the machine is to be permanently demolished and/or
scrapped, divide the material to be disposed of according to
type and composition, as follows:
1) Cast iron or ferrous materials, composed of metal
alone, are secondary raw materials, so they may be taken to
an iron foundry for re-smelting after having removed the
contents (classified in point 3).
2) Electrical components, including the cable and electronic
material (magnetic cards, etc.), fall within the category of
material classified as being assimilated to urban waste
according to the laws of your local, state, or federal
government, so they may be set aside for collection by the
public waste disposal service;
3) Old mineral and synthetic and/or mixed oils, emulsified oils
and greases are considered hazardous or special refuse, so
they must be collected, transported and disposed of at a
special waste disposal service.
NOTE: The standards and legislation concerning refuse is in
a constant state of evolution, therefore is subject to changes.
The user must keep informed of the regulations at the time of
disposal as these may differ from those described above.
5 The machine´s functional parts
5.1 The saw arm
Machine parts consisting of drive members (gear motor or
variable speed motor, flywheels), tightening and guide (blade
tightening slide, blade guide blocks) of tool.
4