The Operation Cycle - Promac SX-823DGVI Mode D'emploi

SX-823 DGVI
SX-827DGVI
5.6 Saw frame moving down flow control
The hydraulic cylinder is ideal for the cutting of thin or
stainless steel section bars that determines a constant
lowering and consequently a good efficiency of the blade
throughout the work phase.
By adjusting the flow control valve (A), this device can be
accommodated to the different situations and applications. (B)
level is on/off switch to control hydraulic flow.

5.7 The operation cycle

Before operating, all the main organs of the machine must be
set in optimum conditions.
C1 Manual position
7