Use Of Main Machine Parts - Promac SX-824DG Mode D'emploi

TELLTALE CHIPS
Chips are the best indicators of correct feed force. Monitor chip information and
adjust feed accordingly.
Thin or powdered chips – increase feed rate or reduce band speed.
Burned heavy chips – reduce feed rate and/or band speed.
Curly silvery and warm chips – optimum feed rate and band speed.

7.USE OF MAIN MACHINE PARTS

7-1.POWER SYSTEMS AND CONTROL PANEL
The electrical rating of your band saw is with
400 volt-3 phase, magnetic control.
Before connecting your machine to an electrical
power system, be sure the motor shaft is
running in the correct direction.
Refer to the electrical wiring diagram supplied
with your machine for instructions on how to
connect saw to power source. Power must be
cut off when wheel cover is opened or during
repairing.
Please check the moving direction of the blade.
If the blade is moving in the wrong direction,
please re-connect the wire.
B
Fig. S1
Operation way :
1. Push the green button(A)(fig.S1) to connect the
A C
D
power for the machine .
2. Fast moving saw-farm to approach cutting
material
Turn the switch (D(fig.S1)) to "Quick" ,push the
handle of limit switch(A)(fig.S2),it can move the
saw farm manually to near the material.
3. Auto Cutting
Turn the switch (D) (fig.S1) to "Automatic" , push
the handle of limit switch(A)(fig.S2) ,
The machine will going down and cut by itself.
Adjust (A) (fig.S3) to set up the down-feed
speed in saw-farm
4. Manual Cutting
Turn the switch (D) (fig.S1) to "Manual " , push
the handle of limit switch(A)(fig.S2),
The machine will convert into the manual
En 7 / 56
Fig. S2