ST Quadrat LUX-top SDH-S Manuel D'utilisation page 17

 A plan must exist, which takes into account the rescue measures for all possible
emergency incidents that can occur during the work.
 Should any doubt occur regarding safe condition (e.g. severe corrosion, lightning
strikes) or following a fall of a person secured on the
product must be withdrawn from further use, it must be inspected by a
competent person and if applicable released for use in writing.
 The lanyard must always be set as short as possible, even when fall arrest systems
are used, in order to reduce any free-fall height in case of a fall to a minimum. For
safety reasons, it is essential that the position of the anchor point and the plan of work
be chosen so that the free fall and the fall height are limited to a minimum. Ideally, a
fall over the edge should be completely prevented by appropriate use of the
PPE against falls from a height.
 If the anchor device is used as part of a fall arrest system the user must be equipped
with an energy absorber, which limits the maximum dynamic forces that act on the
user during an arrest to 6 kN maximum.
 Position the anchor device on the building so that in case of a fall over the roof edge,
the maximum possible fall factor is 1.
 Ensure safe, stable position during use!
 Please note that failing to follow these user instructions, and if the documentation is
incomplete, all claims for compensation are excluded.
 The manufacturer must be contacted in case of any uncertainty during installation or
use of the system!
 A standard operating procedure with information on the location and use of the anchor
devices should be attached at the access to the safety system (e.g. roof hatch).
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection solutions – www.lux-top-absturzsicherungen.de
4
®
LUX-top SDH, the
Version 12/2017