ST Quadrat LUX-top FSE 2003 Instructions De Montage Et D'utilisation page 30

• The stability of the mounting base after a person secured to the
falls, must be checked by a qualified person before re-installing a new anchor device
on site. If necessary, the complete lifeline system including the anchoring system or
individual components must be replaced.
• On-site operating instructions with information on the location and use of the anchor
devices should be attached at the access to the safety system (e.g. roof hatch)!
• In conjunction with the use of the
regulations and the accident prevention regulations and rules of the trade associations
responsible for industrial safety must be complied with. For Germany these include,
among other things:
"Technical rules for health & safety at work -
TRBS 2121
▪
▪ DIN 4426 "Safety requirements for workplaces and transport routes"
▪ DIN 363 "Personal fall protection equipment - personal fall protection systems"
▪ DGUV Regulation 38
▪ DGUV Regulation 112-198
height"
▪ DGUV Information 201-008
▪ DGUV Regulation 101-016 "Roof Work"
DGUVI 201-056
▪
▪ ASR A2.1 "Technical rules for workplaces - Protection against falling and from falling
objects, entering danger areas"
• Make sure to take up a safe stance whilst using the anchor device!
• There must be a rescue plan which takes into consideration all possible emergencies
so that potential rescue operations can be carried out quickly and safely.
• Even when using fall arrest systems, the lanyard must always be set as short as
possible in order to keep the free-fall height to a minimum in case of a fall. It is
essential for safety that the position of the anchor device and the plan of work be
chosen so that any free fall and the fall height are limited to a minimum. Ideally, a
fall over the edge should be completely prevented by appropriate use of the
PFPE.
• Position the anchor device to the building in such a way that fall factor 1 is only
possible at the most when falling over the edge of the roof.
• Please note that if these user instructions are not observed, and if the documentation
is not complete, any recourse claims are excluded.
• In case of uncertainty when installing or using the system, the manufacturer must be
contacted!
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection devices – www.lux-top-absturzsicherungen.de/en
LUX-top
"Construction Work"
"Use of personal protective equipment against falls from a
"Roof Work"
"Planning principles of anchor devices on roofs"
page 4 Version 09/2020
® FSE 2003 system, the relevant national
risk to people due to falling"
LUX-top ® FSE 2003