ST Quadrat LUX-top FSE 2003 Instructions De Montage Et D'utilisation page 34

Application / system description:
The system LUX-top
accordance with DIN EN 795:2012 Type C + CEN / TS16415:2013, which is used for
attaching personal protective equipment against falls from a height during working in
areas subject to the high risk of falling. The purpose of the anchor device is to prevent
persons from falling, or in the event the user falls, to catch the person falling and protect
him from serious or even fatal injuries.
The flexible system can be installed in combination with the above mentioned
anchor points on all components with adequate load bearing capacity. After prior
agreement with the manufacturer, the installation of the system can also be carried out
directly on steel structures and concrete components with sufficient load-bearing capacity.
LUX-top ® FSE 2003
LUX-top ® FSE 2003
In an upright configuration, e.g. on roofs
-
In an inclined configuration, e.g. on sloped surfaces
-
In a horizontal configuration, e.g. on walls and posts
-
Overhead configuration e.g. on ceilings and beams
-
During proper use of the system the maximum force, which is passed to the building
structure on the endpoints of the anchor device, is 12 kN in the event of a fall. During use
of the LUX-top ® SKE II the maximum force on the end points can be reduced to 8.2 kN.
The anchor device
persons with full body harnesses and energy absorbers (including any necessary persons
for first aid/rescue).
Even a system which has already been deformed by a fall can generally still be used for
the rescue of fallen persons.
The LUX-top ® FSE 2003
363:2008:
• Restraint systems
• Fall arrest systems
• Rescue systems
The respective user instructions of the other personal fall protection equipment
and abseiling and rescue equipment used must also be observed!
LUX-top ® FSE 2003
rope access techniques (abseiling, etc.) or for positioning people!
Materials:
The lifeline systems are manufactured from the materials 1.4301,
and 1.4404.
*) When using the system in Germany, the information provided in the national technical approval Z-14.9-789
must be observed.
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection devices – www.lux-top-absturzsicherungen.de/en
® FSE 2003 is an anchor device with a flexible anchor line in
is intended for loading in all directions.
can be installed and used in the following configurations:
LUX-top ® FSE 2003
*)
can be used in the following fall protection systems to EN
may not be used as an anchor device for suspension systems with
page 8 Version 09/2020
is approved for the simultaneous use of up to 6
LUX-top ® -
*)
*)
1.4307, 1.4401,