ST Quadrat LUX-top FSE 2003 Instructions De Montage Et D'utilisation page 38

Masquer les pouces Voir aussi pour LUX-top FSE 2003:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

(1) LUX-top
®
stainless steel rope 8.0 mm
Design 7x7 - Minimum breaking force 36 kN AISI 316 as permanently remaining guide rope in LUX-
top
®
FSE 2003 rope -based fall-arrest system.
(2) LUX-top
®
tensioning device
Factory pressed as a tensioning element in LUX-top
Also available for self-pressing for trained LUX-top
(3) LUX-top
®
end terminal
Factory pressed - as connection between stainless steel rope and end anchor in LUX-top
lifeline systems.
Also available for self-pressing for trained LUX-top
(4) LUX-top
®
SKE II
Serves as a tool for defining the tension of the stainless steel rope, as well as an energy absorber in
the event of a falling load and also protects the system against extraordinary loads due to thermally
induced change in length.
(5) LUX-top
®
butt connector
For the straight coupling of stainless steel ropes in LUX-top
(6) LUX-top
®
corner connector
For coupling two stainless steel ropes on the corner point in LUX-top
(7) LUX-top
®
distribution disc
For coupling several stainless steel ropes in LUX-top
(8) LUX-top
®
corner rope protector
As a rope support on the corner points of LUX-top
Available in the versions 45°, 90°, 115° and 135°.
(9) LUX-top
®
rope guide - straight - type SZH-Z
Enables the free traversing of intermediate hold points
systems.
Design:
for double-sided use
(10)
LUX-top
®
rope guide - one-sided - type SZH-E
Enables the free traversing of intermediate hold points in LUX-top
systems.
Design: for one-sided use
(11) LUX-top
®
rope guide - wall- and ceiling installation - type SZH-W
Enables the free traversing of intermediate hold points in LUX-top
systems.
Design: cropped for wall installation and ceiling installation (overhead installation).
Under certain conditions, installation without an additional anchor point directly on the substructure
is possible.
PLEASE ASK THE MANUFACTURER!
(12) LUX-top
®
rope guide - top - type SZH-O
As rope guide that can be screwed directly onto the side of steel components (overhead
installation).
(13) LUX-top
®
rope guide 90°
Enables the free traversing of corner points in LUX-top
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection devices – www.lux-top-absturzsicherungen.de/en
®
FSE 2003 lifeline systems.
®
installers.
®
installers.
®
FSE 2003 lifeline systems.
®
FSE 2003 lifeline systems.
®
FSE 2003 rope-based fall-arrest system.
in LUX-top
®
FSE 2003 stainless steel lifeline systems.
page 12 Version 09/2020
®
®
FSE 2003 lifeline systems.
®
FSE 2003 stainless steel lifeline
®
FSE 2003 stainless steel lifeline
®
FSE 2003 stainless steel lifeline
FSE 2003

Publicité

Table des Matières
loading

Table des Matières