Sa20 Specifications - Arcam HDA SA10 Manuel

SA20 Specifications

Continuous power output (0.5% THD), per channel
Both channels, 8Ω, 20Hz—20kHz
Both channels, 4Ω, at 1kHz
Harmonic distortion, 80% power, 8Ω at 1kHz
Analogue Inputs
Phono (MM) cartridge:
Input sensitivity at 1kHz
Input impedance
Frequency response (ref. RIAA curve)
Signal/Noise ratio (A-wtd) 50W, ref. 5mV input
Overload margin, ref. 5mV at 1kHz
Line Inputs:
Nominal sensitivity
Input impedance
Maximum input
Frequency response
Signal/Noise ratio (A-wtd) 50W, ref. 1V input
Digital Inputs
DAC
Frequency response
Total harmonics distortion + Noise
Signal/Noise ratio (A-wtd)
Supported sample rates Optical
Coaxial
Bit depth
90W
150W
0.002%
5mV
47kΩ + 100pF
20Hz – 20kHz ± 1dB
80dB
21dB
1V
10kΩ
6Vrms
20Hz – 20kHz ± 0.2dB
106dB
ESS9038K2M
20Hz - 20kHz ± 0.05dB
0.0007%
115dB
32kHz, 44.1kHz, 48kHz, 88.2kHz, 96kHz
32kHz, 44.1kHz, 48kHz, 88.2kHz, 96kHz, 176.4kHz, 192kHz
16-bit – 24-bit
Pre-amplifier output
Nominal output level
Output impedance
Headphone output
Maximum output level into 600Ω
Output impedance
Load range
General
Mains voltage
Maximum power consumption
Dimensions W x H x D (including feet, control
knob and speaker terminals)
Weight (net)
Weight (gross)
Supplied accessories
EN-17
630mV
230Ω
5Vrms
1Ω
16Ω – 2kΩ
110–120V or 220–240V, 50–60Hz
500W
433x87x323mm
9.2kg
11.1kg
Mains leads
Remote control
2 x AAA batteries
All specification values are typical unless otherwise
stated. Arcam has a policy of continuous improvement
for its products. This means that designs and
specifications are subject to change without notice.
E&OE.
EN