Specifications - Arcam FMJ P777 Manuel

specifications

All measurements are with 230V/50Hz mains power
Maximum continuous output power
All channels driven, 20Hz–20kHz, 8Ω
All channels driven, 20Hz–20kHz, 4Ω
One or two channels driven at 1kHz, 8Ω
One or two channels driven at 1kHz, 4Ω
Total harmonic distortion
At any level up to rated power, into 4Ω or 8Ω
Frequency response
Residual hum and noise
Ref. full power
Voltage gain
Input impedance
General
Power requirements
Physical
E&OE
NOTe: All specification values are typical unless otherwise stated
160W per channel; 1.05kW total
270W per channel; 1.62kW total
170W per channel
290W per channel
Typically <0.004% at 1kHz
Less than –0.3dB (10Hz—20kHz)
–3dB at 100kHz
–108dB, 20Hz–20kHz, unweighted
x 37 (31.5dB), Arcam standard
470pF in parallel with 22kΩ
115V or 230VAC, 50/60Hz, 1200W maximum via heavy
duty IEC C20 mains inlet (requires IEC C19 plug).
A soft start system eliminates large inrush currents at
switch on.
Dimensions: W430 x D450 x H180mm
Weight: 37.2kg net; 40kg packed
e-11
continual improvement policy
Arcam has a policy of continual improvement for its
products. This means that designs and specifications
are subject to change without notice.
Radio interference
The P777 is an audio device which has been
designed to very high standards of electromagnetic
compatibility.
The unit can radiate RF (radio frequency) energy.
In some cases this can cause interference with FM
and AM radio reception. If this is the case, keep the
P777 and its connecting cables as far from the tuner
and its aerials as possible. Connecting the P777 and
the tuner to different mains sockets can also help to
reduce interference.
eC Countries – These products have been designed
to comply with directive 89/336/EEC.
USA – These products comply with FCC
requirements.