Technical Specifications - Arcam RMJ C30 Mode D'emploi

Technical specifications

Continuous power output (20Hz—20kHz at 0.5% THD), per channel
Both channels, 8Ω, 20Hz—20kHz
Single channel, 8Ω, 20Hz—20kHz
Both channels, 4Ω, 20Hz—20kHz
Single channel, 4Ω, at 1kHz
Three channels, 8Ω, 20Hz—20kHz
Harmonic distortion, 80% power, 8Ω at 1kHz
Inputs
Phono cartridge:
Input sensitivity
Input impedance
Signal/noise ratio (CCIR)
Overload margin
Line and tape inputs:
Nominal sensitivity
Input impedance
Signal/noise ratio (CCIR)
Tone controls, max. boost/cut
Power amplifier input
Nominal sensitivity
Input impedance
Gain
Preamplifier output
Nominal output level
Maximum output level
Output impedance
Headphone output
Maximum output level into 600Ω
Output impedance
General
Mains voltage
Power consumption (maximum)
Power consumption (standby)
Dimensions W x D x H (including feet)
Weight (net)
Weight (packed)
Supplied accessories
E&OE
CONTINUAL IMPROVEMENT POLICY
Arcam has a policy of continual improvement for its products. This
means that designs and specifications are subject to change without
notice.
C30
2.7mV (MM); 270µV (MC)
47kΩ (MM); 300Ω (MC)
–79dB (MM); –73dB (MC)
35dB
250mV—2V
22kΩ
–103dB
±12dB @ 80Hz and 12kHz
700mV
8V RMS
<50Ω
5V
4.7Ω
115V or 230V
30VA
2VA
430 x 370 x 110mm
9.3kg
11.5kg
mains lead
CR-389 remote control
2 x AAA batteries
NOTE: All specification values are typical unless otherwise stated.
14 14
P35
100W
150W
140W
200W
90W
0.005%
800mV
22kΩ
–110dB
800mV
22kΩ
31.5dB
115V or 230V
800VA (950VA for P35/3)
2VA
430 x 350 x 110mm
9.5kg (10.5kg for P35/3)
12.5kg (13.5kg for P35/3)
mains lead
P1
170W
250W
0.003%
906mV (Arcam gain)
22kΩ
31.5dB (Arcam gain)
115V or 230V
800VA
2VA
430 x 350 x 110mm
12.5kg
15.5kg
mains lead