Advice For Use; Safety Systems - Zummo Z14 Manuel D'utilisation

6.8. ADVICE FOR USE

•
Always make sure you are using the right squeezing set of Balls, Cups and Fruit Classifier for the
size of fruit you wish to squeeze. If the fruit to squeeze is too big or too small for the squeezing kit
used, the quality of the juice may decrease, resulting in a bitter juice flavour.
•
The Hopper Fruit Classifier must be correctly selected according to the size of the fruit to squeeze.
•
If fruits are too large for the Fruit Classifier, the fruit will not fall into the Cup. If fruits are otherwise
too small, numerous pieces of fruits will fall at the same time into the Cup.
•
We recommend to switch off the machine when is not in use. (Fig. 3)

6.9. SAFETY SYSTEMS

The machine has various safety systems:
1 If the Front Cover is not assembled or is improperly assembled, the display will show an
Error message with the Front Cover and Hopper symbols flashing.
2 If the tray is not assembled or is not in place, the machine will not operate and the display
will show an Error message by displaying a flashing dark tray.
3 If for any reason the machine gets blocked during operation, after a few seconds the motor
will stop automatically and the display will show an Error message with a faulty flashing
icon, until the cause of the blockage is removed.
4 Thanks to a thermal protection system in the motor, in the event of overheating the machine
will stop and the display will show an Error message and a thermometer icon. In this case,
please wait approximately 10 minutes to allow the motor temperature to decrease. The
error message will disappear. Please check that the ventilation gratings are not obstructed.
5 If there is no message on the display, it means there is no power supply. Check that the
power switch is on and that the plug fuse is not burnt out (Fig.16).
29