Cleaning The Feeder; Advice For Use - Zummo Z40 Nature Manuel D'utilisation


Ensure that the side panels are properly coupled with the locking system for the
machine to operate properly.
If Blade, Juice tray, Balls, Cups, Side cover or Front cover are not correctly assembled, serious
damage may be caused to these parts or to the interior components of the machine.
(Operator faults not covered by the guarantee)
Z40 Manual Mode: The display will show the number of oranges to be squeezed. The machine
is now ready for operation.
Z40 Self-service Mode: When the machine is ready to work, the display show the "machine icon
and the orange icon".

Cleaning the feeder


Undo the basket's retaining nut (Fig. 24).

Remove the external basket by turning it gently.

Unscrew the Nut located inside the basket (Fig. 25).

Remove the Hopper Fruit Classifier pulling it upwards (Fig. 26).

Remove the basket together with the lower fruit classifier by pulling upwards until it is
completely released from its shaft (Fig. 27a-27b).

Clean all the pieces with soapy water or put them in the dishwasher.

Reassemble in this order: first fit the basket together with the lower fruit classifier onto the
shaft (fit the lower fruit classifier in the position of the calibre of oranges you intend to
squeeze, either for the medium kit (Fig. 4) or the large kit (Fig. 5); for the extra-large kit it
should be removed (Fig. 6) and then turn the basket manually until it is anchored (the pivots
should enter their respective holes). Then affix the fruit classifier inside the basket, making
sure it fits properly and cannot turn (Fig. 26), screw in the nut and finally fit the external basket
(Fig. 24).
Important Notice:
The normal use of the machine may cause the plastic parts that are exposed to juice to turn
orange colour. This is completely normal and does not imply a hygiene problem or affect the
physical properties of the plastic.

6.8. ADVICE FOR USE


Always make sure you are using the right squeezing set of Balls, Cups and Fruit Classifier
for the size of fruit you wish to squeeze. If the fruit to squeeze is too big or too small for the
squeezing kit used, the quality of the juice may decrease, resulting in a bitter juice flavour.

The Hopper Fruit Classifier must be correctly selected according to the size of the fruit to
squeeze.

If fruits are too large for the Fruit Classifier, the fruit will not fall into the Cup. If fruits are
otherwise too small, numerous pieces of fruits will fall at the same time into the Cup.

We recommend to switch off the machine when is not in use (Fig. 11).

If the orange has a very thin peel, we recommend that you add a washer to each of the
squeezing balls.
33