Use Recommendations - Zummo Z08 Manuel D'utilisation

Assembly
After all squeezing parts have been washed, put them back in the following order:
Properly screw the Balls inside the Juice Tray making sure to fit three washers under the
1
Balls.
Make sure the Blade Elastic Bands are fitted properly according to the Cups and Ball set
2
used (Fig. 19).
Put the Blade inside the Juice Tray.
3
Assemble both Juice Tray and Blade set on the machine's three front shafts
4
simultaneously. (Fig. 13). Never mount the Blade on the Juice Tray afterwards!! Push
the Blade to the front of the machine until it makes contact with the blade guide on the
front of the machine. (Fig. 14).
Place the Cups on the shafts and tighten the Fastening nuts.
5
Place the Front Cover back in place making sure its clasps fit correctly into the slots
6
located on machine front. (Fig. 8 y 9)
Before operating the machine, double check that:
•
Juice Tray and Blade are properly in place and Fastening Nuts tightened.
•
Blade is properly in place and in horizontal position.
•
Cups are properly tightened.
In the event that Juice Tray, balls or cups were not properly fitted, serious damage may occur to
the machine. This damage will not be not covered by the guarantee.
Cleaning the loader
•
On a daily basis, remove and clean the Complete Roller Track (Fig. 12) that is located on
the top of the machine and clean it. The rollers should always move easily.
•
Unscrew the Hopper Knob that on top of the Hopper. (Fig. 15)
•
Remove the Hopper Plate by pulling it upwards. (Fig. 16)
•
Remove the entire Hopper off his shaft by pulling up. (Fig. 17)
•
Wash the Hopper components using soap and water and place back all parts in the
following order:
- Place the Hopper on the shaft
- Turn the basket clockwise until the Hopper studs have entered into their respective
holes. (Fig. 18)
- Place the Hopper Plate on top of the Hopper so that it cannot turn.
- Lastly, screw the Hopper Plate knob without forcing it.
ATTENTION!: If the basket is not properly into place, the synchronisation between the
Hopper and the Cups will not be correct. This may cause oranges falling in the wrong place
and trapped between the Front Cover and the Cup. As a result, the Front Cover may break.
9

USE RECOMMENDATIONS

•
Use only oranges sized Ø60 a Ø80 that fall freely into the Hopper. Never force oranges into
the Hopper. Bigger oranges forced to enter into the Hopper may get trapped between the
Front Cover and the Cup and possibly break the Front Cover. In this case, breakage of the
Front Cover will not be covered by the guarantee.
•
In the case that an orange get trapped between the Front Cover and the Cup, cut the
orange using a knife in order to remove it easily.
•
Oranges used must fit into the cups. If oranges are bigger or smaller for the size of the
Cups, the juice obtain may contain peel oil and bitter flavour.
•
When the machine is not to be operated, we recommend to switch it off (Fig. 6)
•
Use of bigger or smaller oranges to the recommended in this manual and lack of cleaning of
the Roller Track shall cause malfunctioning of the orange feeding system and breakages of
the Front Cover and Hopper Discharger-Tube. Those are not cover by the guarantee.
15