Changing Operational Mode; Self-Service 230V Model ); Maintenance; Identifying Damages - Zummo Z14 Manuel D'utilisation

7.2. CHANGING OPERATIONAL MODE (

TO GO FROM SELF-SERVICE TO NORMAL OPERATING MODE (from Self-service to Z14)
Turn off the machine by the main power switch.
With the machine turned off, press STOP, keep it held down, and then turn the main power switch on,
holding it for 4 seconds, until a screen with four numbers appears.
When this screen is displayed, find number 1001 - pressing ON moves through the two digits on the
right, and pressing SELECT moves through those on the left – then press STOP (when you press
STOP the display will show ----) and then turn the machine off by the main power switch (if the machine
is not turned off, you cannot move out of this display).
When you turn the machine on again (you will first see the programme version and then code 1001)
the ON and SELECT buttons will have been enabled and machine is now ready to select the number
of oranges you want to squeeze and start operating when you press the ON button.
TO TURN ON THE SELF-SERVICE FUNCTION AGAIN
Repeat the process by entering the code 4104. This will disable the ON and SELECT buttons and the
machine will start working when you turn on the tap.

7.3. MAINTENANCE

Exterior machine maintenance: Consists of just daily cleaning.
Interior of the machine: After every 150.000 cycles, the inner machine guides and springs must be
lubricated and a full cleaning carried out.

7.4. IDENTIFYING DAMAGES

Damage
The display is not lit
The display shows
message Error
The display shows
message Error and a
flashing Icon.
Blade breaks
32
Cause and/or solution
No power supply.
Fuse burnt out. (Fig. 16)
Power cable not properly connected.
Switch power on. (Fig. 3)
Damp circuit board. Supply dry heat to the board.
Casing not fitted correctly (Disp. 5). (Fig. 7)
Hopper Track not fitted correctly. (Disp. 5)
Tray not assembled or incorrectly assembled (Disp. 6). (Fig.8a-8b)
Disp. 5
Check if the fruit is frozen.
Check for piled-up fruit peels inside the Juice tray.
Check if Balls are correctly tightened
Check to see if the orange peels are stuck to the inside of the Cups.
Check if components of different squeezing sets are mixed
To unblock the machine, use the 5mm Allen key located at the right of the
lower vent. Insert it into the hole on the right side and, with the machine
switched off, turn clockwise until the cups are raised, removing the
obstruction. WARNING: Make sure the Allen key is removed before
switching the machine on.
The Peel Extracting Bands are loose or broken and peels are piling up in the
Juice tray.
Cup nuts are too loose.
Balls are loose.
Self-service 230V model
Disp. 6
)