Cleaning The Feeder; Important Notice - Zummo Z14 Manuel D'utilisation

Assembly
After cleaning the whole unit, it is re-assembled as follows:
1 Fit the Cups on the machine front shafts and tighten the Fastening Nuts.
2 Fit the washers on the Juice tray and screw the Balls, making sure they are properly tightened.
3 Insert the blade in the squeezer tray and slot the ribs into the grooves of the balls. Check that
the blade slides easily.
4 Assemble both Juice tray and Blade in the machine's three shafts simultaneously. Never fit the
Blade on the Juice tray afterwards!! To introduce the Blade into the Blade shaft, slightly
press down the Blade push it into the shaft. ATTENTION!!! Never press down the metal
part of the Blade.
5 Fit the Front Cover in place by fitting its clasps into the slots. Make sure that the clasps fit
correctly into the slots. You will hear a small click.
6 Put the Plastic Bins Base and the Plastic Bins in place.
Before operating the machine, make sure that:
•
Juice tray and Blade are properly fitted in place.
•
Fastening Nuts are properly tightened.
•
The correct set of squeezing parts (Balls, Cups and Fruit Selector) are fitted. (see
"Accessories" in this manual).
If Blade, Juice tray, Balls or Cups are not correctly assembled, serious damage may be caused to these
parts or to the interior components of the machine.
(Z14 Model) The display will show the number of oranges to be squeezed. The machine is now ready
for operation.
(Z14 Self-service Model) When the machine is ready to work, the display show the "machine icon and
the orange icon".

Cleaning the feeder

•
Unscrew the Nut located inside the basket. (Fig. 13)
•
Remove the Hopper Fruit Classifier pulling it upwards. (Fig. 14)
•
Remove the Hopper Basket pulling it upwards until it is completely removed from the shaft. (Fig. 15)
•
Remove the Hopper Track.
•
Clean all parts with soapy water or using a dishwasher machine.
Reassemble the parts as follows:
•
Assemble the Hopper Track,
•
Fit the Hopper Basket onto the shaft ;
•
Turn the Hopper Basket clockwise until it gets locked. The pins should have entered into their
respective holes.
•
Assemble the Hopper Fruit Classifier into the Hopper Basket until it gets locked into place.
•
Screw the Basket top nut.

Important Notice

The normal use of the machine may cause the plastic parts that are exposed to juice to turn orange colour.
This is completely normal and does not imply a hygiene problem or affect the physical properties of the
plastic.
SELF-SERVICE MODEL:
formed plastic. They must not be subjected to temperatures higher than 40°C, so they should never be
washed in very hot water or in a dishwasher; if they are deformed by heat, the warranty will not apply.
28
(Operator faults not covered by the guarantee)
Refs. 1402017 drip tray and 1409001 faucet tray, are made from heat-