Loading And Cleaning (Chapter 1); Orange Loading; Glass Loading; Cleaning - Zummo Z10 Manuel D'utilisation

1. LOADING AND CLEANING
 Access to the service area is only permitted to people with the appropriate training and
knowledge to load and clean the machine, especially regarding matters of hygiene and
safety.
 Machine operators are responsible for their personal hygiene and cleanliness in compliance
with current health and safety regulations.
 The product provided by the machine is citrus fruit juice with a pH level no higher than 4.5.
 Cleaning must be undertaken using a detergent suitable for foodstuffs which does not
require rinsing with water.
Product dosage should follow the amounts specified in the technical data sheet.
 It is advisable to use soft water for cleaning the machine.
 It is advisable to turn off the main switch of the machine before starting any cleaning
procedures. Do not clean the machine with direct jets of water or water at high pressure.
 We recommend a thorough wash of the parts that are in the squeezing area unless once a
week (CUPS, INTERIOR FILTER, SQUEEZING TRAY, BLADE and SQUEEZER FRONT
COVER), MACHINE DOOR, DRIP GRILLE, EXTERIOR FILTER and EXTERIOR FILTER
TRAY following the cleaning instructions.

1.1. ORANGE LOADING

 The machine is prepared to squeeze oranges with a diameter of 55 to 75 mm. (with the set
of green cups and balls), if you wish to squeeze oranges with a larger diameter, use red
cups and balls that allow oranges with a diameter of 70 to 90 mm. to be squeezed.
 45 to 50 kg. fit on the loader (Scheme 1, No. 14), depending on the type of orange.
 Every time the machine is loaded, ensure that an orange is placed in the left hand cup
(Scheme 1, No. 8).
 ATTENTION!: Do not excessively fill the hopper. There must be a gap of at least 15cm.
underneath the rollers (Fig. 17). If you fill it over this level, when the oranges rise, the rollers
may come out of their housing and the machine will signal a fault and will become out of
service. (Fig. 18).
 Do not fill with oranges in bad condition.

1.2. GLASS LOADING

 Ø70 glasses must be placed in the glass loader (Fig. 19), which may have different
capacities of 150, 220 or 250cc with Ø73*.
 120 to 140 glasses fit, depending on the manufacturer and glass capacity.
 We recommend the use of antistatic treated glasses.
 The colour of the glasses is indifferent.
 You can test the working of the glass loader manually by pressing button S4 on the control
plate.
 ATTENTION!: Please observe that the glasses are not oval nor are they excessively stuck
together.
* Optional accessories, not included as standard

1.3. CLEANING

 SQUEEZING AREA:
Dismantling:
- Unscrew the nut holding the FRONT COVER, (Fig. 20) remove the FRONT COVER
and clean it with a cloth and soapy water. (ATTENTION!: Do not use abrasives
and NEVER clean with product that may scratch).
24