Functions And Cleaning; Initial Start-Up - Zummo Nature Z40 Adapt Manuel D'utilisation

6. FUNCTIONS AND CLEANING

•
It is advisable to turn the machine off at the mains before starting any cleaning processes.
•
Do not wash the machine using water jets and/or water at high pressure.
•
We recommend at least one daily clean of the components in the juice squeezing zone* (cups,
squeezing balls, drip tray, filter, blade and cover), following the cleaning instructions.
•
The product provided by the machine is citrus juice with a pH level of 4.5, which is not
considered as being a potentially dangerous foodstuff.
* For the Z40 Nature Garnetfruit model or an use with pomegranates, it is recommended to clean
this zone every 50Kg of squeezed fruit.

6.1. INITIAL START-UP

•
Depending on the size of the fruits to be squeezed, select the correct size of cup and ball and
the fruit classifier for the basket and position the lower fruit classifier correctly. See the section
on ACCESSORIES.
•
Fit all the parts in their correct positions. See assembly in the section on CLEANING. If you
have a Service model (with a tank), fit the support on the base of the machine (Fig. 9).
•
Do not place your hand into the basket while the machine is operating (Fig. 10).
•
The Self Service Adapt tray has two operating modes:
- Manual Mode: Select the number of fruits to be squeezed in the display. When you
press ON, the machine will squeeze the number of fruits selected.
- Self-Service Mode: When you press the tap down, the juicer will start working. For
stop the machine, release the tap.
Z40 Manual Mode:
- Once the machine is switched on, the display will show either a number between 1 and
999 or the letter C. The number indicates the quantity of fruits to be squeezed, while the
letter C sets the machine to squeeze continuously for approximately 30 minutes.
- To set the number of fruits to squeeze, press the SELECT button repeatedly to increase
the number (from 1 to 999, followed by the letter C. (1,2,3, ..........997,998,999, C,1,2,3....).
Alternatively, press and hold the SELECT button for 2 seconds and the number will
decrease.
- Continue until you visualize the wanted number.
- The selected number will be stored on the display after the first complete squeeze cycle
is finished. The number will be stored even if the machine is switched off. You may
change the number repeating the complete number selection process.
- Press the ON button to start squeezing. During the process, the display will show the
remaining amount of fruits to be squeezed. If you wish to repeat the process, simply
press ON. To stop the process, press the STOP button.
Important Notice:
For Manual mode, the tap must be activated permanently. Actuate it and turn the knob that moves
the cam to fix it.
29