Application Restrictions - 3M DBI-SALA 8510715 Mode D'emploi

;
Prior to installation and use of this equipment, record the product identification information from the ID label in the
Inspection and Maintenance Log at the back of this manual.
PRODUCT DESCRIPTION:
Figure 1 illustrates the 3M™ DBI-SALA™ Adjustable Barrel Mount Sleeve.
Figure 2 illustrates the components of the Adjustable Barrel Mount Sleeve System. See Table 1 for Component Specifications.
SPECIFICATIONS
Component Specifications:
Figure 2
Reference Component
A Lock Pin
B Adjustment Tube
C Stop Collar Barrel Mount
D Adjustment Screw
E Davit Sleeve
General Specifications:
Rated Capacity (working load)
Moment Load
Davit Arm Rotation
Davit Arm Offset
Weight
Materials and Construction:
General Construction
Weld Certification
Base Material
Sleeve Bearing Material
Thrust Bearing Material
Hardware
Table 1 – Specifications
DESCRIPTION:
THESE BASES ARE ONLY COMPATIBLE WITH DBI SALA DAVIT
A
MASTS AND EXTENSIONS.
The Adjustable Barrel Mounting Sleeve is designed for shoring, wall and parapet
applications where frequent setup over varying wall thicknesses is required. Specific
models will accommodate the various wall thicknesses. The unit consists of welded
aluminum, zinc plated steel hardware, and a PVC sleeve liner. The table below lists
maximum wall thickness as shown in Figure 7 (A).
Model Number
8510715
8512285
8562285
Materials
18-8 Stainless Steel
Aluminum
Aluminum
Steel
Aluminum
310 lbs (141 kg)
64,125 in-lbs (7.3 kN-M.)
Rotation is only allowed to
move personnel away from
the fall hazard. No fall hazard
may be present when davit
arm is rotated. When using
davit arm for fall arrest, the
davit arm must only be used
straight out, (perpendicular
to the structure face).
11-1/2" - 27-1/2"
(29.2cm - 69.8cm)
56 lbs. (25.5 kg)
Welded Aluminum
AWS
6061-T6 Aluminum
PVC Pipe – STM-D-1785
High Density Polyethene
GR.5 / Zinc Plated
Maximum Wall Thickness
12 in (30.5cm)
24 in (61cm)
24 in (61cm)

Application Restrictions:

1. Sleeves are for use with masts &
accessories manufactured by DBI-SALA
ONLY.
2. System design factor depends on other
system components and the configuration
in which they are assembled. The
minimum design factor for all standard
DBI-SALA Safety Systems masts and
accessories is 2:1.
3. If base material does not meet minimum
requirements, reinforcement MUST BE
added to meet minimum requirements.
4. Each installation MUST BE approved to
local standards by a qualified engineer.
7