Cutting Height Adjustment - Güde ECO WHEELER 410 P Traduction Du Mode D'emploi D'origine

Operating (Fig. 2)
Lever for automatic stopping (12) – press the lever
towards the handle when starting. If you want to switch the
engine off release the lever.
Use
1. Mowing (without collector)
Mown grass is stored in stripes.
2. Mow and collect
Grass is collected in the collector. (wet and wet grass reduced
the FAD) in the collector. To mount the pot on the mower, lift
the cover plate and hook the pot.

CUTTING HEIGHT ADJUSTMENT

Depending on the cutting height required it is necessary to adjust
the height of wheels. Adjust the cutting height with the help of the
wheel axle to each wheel individually, your wish, and one. The
middle position is most suitable at most mowers.
Remove to change the cutting height of the hubcaps.
ADD OIL BEFORE STARTING
The oil level needs to be checked before each use. Fill up
oil as needed (500ml SAE30 engine oil).
OIL FUNNEL CAP – OIL DIPSTICK
UPPER LIMIT
BOTTOM LIMIT
The mower is supplied without oil in the engine.
WARNING: Be careful not to overfill the engine with oil,
failing which the absorber would smoke when starting.
1. Make sure the mower stands on a flat surface.
2. Take out the oil tank cover.
3. Insert the oil dipstick and fix it.
IMPORTANT:
The oil level needs to be checked before each use. If
•
necessary, add oil to the marking on the oil dipstick.
•
The oil must be changed after 25 hours of operation or each
season. At works in a dusty or polluted environment the oil
may need to be changed more often. See " OIL CHANGE " in
the Maintenance article in these operating instructions (SAE
30).
FUEL ADDING (unleaded petrol)
• • The fuel is added through the filling hole in the tank.
Pay attention not to spill the petrol. Use common clean
unleaded petrol. Do not mix the petrol with oil. Always buy only
reasonable volume of petrol so that you could consume it within
30 days.
Motor oil must necessarily be added to the engine before
putting the appliance into operation for the first time. Check the
oil level whenever the appliance is to be started.
FUEL ADDING (unleaded petrol)
The fuel is added through the filling hole in the tank. Pay
attention not to spill the petrol. Use common clean unleaded
petrol. Do not mix the petrol with oil. Always buy only
reasonable volume of petrol so that you could consume it
within 30 days.
WARNING: Wipe any spilled oil or petrol. Do not
store, pour, use near open fire.
FUEL TANK CAP
WARNING: Alcohol-enriched fuels (gasohol) or fuels with
ethyl alcohol or methanol mixtures may attract humidity and
subsequent acid formation. The clean petrol may as a result of
long storage damage the engine fuel system. If you want to
prevent engine problems you should empty the fuel system
before storing for more than 30 days. Empty the fuel tank, start
the engine and let it run until the fuel system and carburettor
are empty. Add fresh fuel each season. See the storing
instructions, too. Never pour cleaners to the fuel tank to clean
the engine or carburettor. By doing so, you could cause
irreparable engine damage.
ENGINE STARTING (Fig. 1,2)
At starting first make sure the spark plug is in its place and
there is sufficient amount of oil and petrol in the device.
CAUTION: The engine may smoke at first starting due to
protective oil film on the inner engine surface. Consider this as
normal.
13