Safety Functions; Hood Safety Switch; Troubleshooting; Scrapping - Nilfisk Alto FLOORTEC 550 B Manuel D'utilisation

SAFETY FUNCTIONS

HOOD SAFETY SWITCH

It is activated when the machine hood is raised. It stops all
functions.
In case of machine start even when the hood is open,
contact an authorized Service Center or Retailer.

TROUBLESHOOTING

TROUBLE
When the key is to "I" position
the machine does not start.
The side broom does not
operate.
The machine operates only
when stationary, otherwise the
red warning light turns on.
The battery autonomy is low.
NOTE
If the machine has an optional battery charger
installed, the machine cannot operate if the
charger is not on board. In case of battery
charger malfunction, contact an authorised
Service Center.
For further information, refer to the Service Manual,
available at any Nilfisk-Alto Service Center.
146 2357 000(1)2005-03 A
REMEDY
Check that the connector 3, Fig. T
is properly connected.
Check that the hood is correctly
closed.
Check the fuse (6, Fig. T) integrity.
Check that the optional battery
charger is not connected.
Check the fuse (7, Fig. T) integrity.
Re-charge the battery.
If the problem persists, replace the
battery.
Install a battery with greater
capacity. (min. 140 Ah)
USER MANUAL

SCRAPPING

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove the following
components:
– Battery
– Polyester dust filter
– Main and side brooms
CAUTION!
The removed components must be
disposed of properly according to the Law
in force.
ENGLISH
FLOORTEC 550 B 13