Install The Brushes (Cylindrical System) - Nilfisk Advance SC5000 34D Mode D'emploi

INSTALL THE BRUSHES (CYLINDRICAL SYSTEM)

CAUTION!
Turn the machine OFF at the power switch, before changing the brushes, and before opening any access panels.
Make sure the Scrub Deck is in the RAISED position. Make sure the Power Switch (H) is off.
1
2 See Figure 2-3. Unlatch and swing open both Side Blade Assemblies (AA).
Unhook the Latch (AB) on top of the Idler Assemblies (AC) and remove.
3
4 Slide the brush into the housing, lift slightly, push and turn until the tabs on the drive hub seat into the notches in the brush. NOTE: The idler is designed with
a snug fit into the brush to reduce vibration. Re-install the Idler Assemblies (AC) make sure the tabs on the idler are inside of the weldment (as shown in
inset of Figure 2-3). Secure with Latch (AB). Close and latch both the Blade Assemblies (AA).
FIGURE 2-3
1/2021
INSTRUCTIONS FOR USE
AB
AC
56091219 - Advance SC5000
ENGLISH - A
AA
AC
A - 17