Install The Brushes (Cylindrical System) - Nilfisk Advance SC6500 40C Mode D'emploi

INSTALL THE BRUSHES (CYLINDRICAL SYSTEM)

CAUTION!
Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels.
1 Make sure the Scrub Deck is in the RAISED position. Make sure the Key Switch (A) is off (O).
2 See Figure 3. Remove both side skirt assemblies. NOTE: The skirts are held in place by two large Knobs (AA). Loosen these knobs, slide
the Skirt Assemblies (BB) forward slightly and then off of the Scrub Deck.
3 Loosen the Black Knobs (CC) on top of the Idler Assemblies (DD) until they drop down far enough to disengage from the Notches (EE) and
remove.
4 Slide the brush into the housing, lift slightly, push and turn until it seats. Re-install the Idler Assemblies (DD) and Skirt Assemblies (BB).
FIGURE 3
2/2014
AA
DD
INSTRUCTIONS FOR USE
CC
BB
56091095 - SC6500
ENGLISH - A
EE
A - 11