How To Start And Stop Cleaning; Using The Remote Controller - LG VR6260 Série Guide D'utilisation

HOW TO START AND STOP CLEANING

Using the buttons on the Robot Cleaner
After the Robot Cleaner is turned on, press the START/STOP button to begin
cleaning. A melody will sound and cleaning will begin.
Press the START/STOP button during the cleaning cycle to stop cleaning.
※ When the 'START/STOP' button is pressed while the power supply of the Robot
Cleaner is turned off, the power will be turned on. Press the 'START/STOP' button
one more time to start cleaning.

Using the remote controller

After the Robot Cleaner is turned on from the Robotic Cleaner, press the START
button on the remote control. A melody will sound and cleaning will begin.
Press the STOP button during the cleaning cycle to stop cleaning.
※ The Robot Cleaner cannot be turned on from Stand By, by using the remote
controller when the power of the Robot Cleaner is off. When the power is off,
press the 'START/STOP' button on the upper side of Robot Cleaner to turn the
power on and to allow the remote to be used.
※ During cleaning, collisions can happen when the sensor cannot detect objects because of their shape (Thin chairs and table legs,
furniture corner). When this happens, the internal impact detecting sensor will react by using a backward motion.
※ If the Robot Cleaner is set to start cleaning at a location away from the home station, put the Robot Cleaner on a fl at fl oor in
order to prevent a malfunction of the obstacle detecting sensor. In addition, start cleaning from a location where there are no
obstacles such as curtains or walls within 30 cm of the Robot Cleaner.
Tip
For best results:
• Briefly scan the area to be cleaned for big and small objects that will cause difficulty for the Robot Cleaner.
• If cleaning is started when the Robot Cleaner is at the home station, the device can rapidly be returned to the
home station as the current home position has been accurately read.
• When the mop plate is installed, to prevent a 2
door sills of 5 mm or higher.
16
nd contamination from the contaminated mop, it will not go over