How To Use - LG V-CQ3H Serie Mode D'emploi

E

How to Use

Connecting the flexible hose
Push the end of the head (1) on the flexible
hose (2) into the attachment point on the
vacuum cleaner.
To remove the flexible hose from the
vacuum cleaner, press on the button (3)
situated on the head, then pull upwards.
Assembling the tubes
• Telescopic tube (4)
- Hold spring latch (5)
- Pull out the tube to required length.
- Release spring latch to lock.
Using the cleaning head and Accessory
Fit the large cleaning head onto the end of the
tube.
• The 2 position head (6) is equipped with a
pedal (7) which allows you to alter its
position according to the type of floor to be
cleaned. Hard floor position(tiles, parquet
floors...). Press on the pedal to lower the
brush. Carpet or rug position. Press on
the pedal to lift the brush up.
Dust bag storage(8)
Dust bag storage(8) can easily lay up the
new dust bag.
It prevent dust bag from missing.
How to plug in and use
Pull out the mains lead to the desired
length and plug into the socket.
Slide button (9) to start the vacuum
cleaner. To stop it slide the button (9)
again.
Electronic power control(9)
Suction capacity increases steplessly up
to MAX.
OFF : Power off CURTAIN : Low
FLOOR : Full power.
Urethane Wheel(10), (11)
The three urethane wheel of stairs(10)
and urethane wheel(11) prevent a scratch
on the floor.
They reduce the rolling noise.
All manuals and user guides at all-guides.com
LED Display (13)
YELLOW: Power on
Park-System (14)
For short breaks during vacuuming, for
example to move a small piece of
furniture or a rug, use the Park system to
support the flexible hose and cleaning
head.
• Slide the hook attached to the large
cleaning tool into the slot on the rear of
the appliance.
Carring and storage (15)
When you have switched off and
unplugged the appliance, press on the
button (12) to automatically rewind the
cord.
You can move or store your appliance in
a vertical position by sliding the hook on
the large cleaning head into the clip on
the underside of the appliance.
Changing the dust bag
The dustbag needs changing when the
cleaner is set to maximum power and the
cleaner head is off the floor but the "bag
full" indicator window (16) is completely
coloured red.
Even if the dustbag does not appear to be
full at this stage, it should be changed.
It could be that a great deal of very fine
dust has clogged up the pores of the dust
bag.
• Turn off the appliance and unplug it.
• Open the cover by pulling the cover(17).
Your appliance is equipped with either a
paper dust bag or a fabric dust bag (26)
(depending on model)
• Pull out the filter bag carrier.
• Push the latch (18) forwards in the
direction of the arrow and remove the
full dust bag throw it away.
• Insert the new dust bag into the
cleaner(19).
If your appliance is fitted with a fab-
ric dust bag
follow the same
instructionsas above.
Empty it and reuse it (26).
Do not wash it.
- 12 -