LG VR6260 Série Guide D'utilisation page 22

CLEANING MODES
My Space Cleaning
Pressing 'My Space' on Remote Controller will set the My Space
cleaning mode with a voice message.
For cleaning of particular spaces, select this mode.
The 1st stage:
Use the Remote Controller to manually run
the cleaning on outskirts of each cleaning block.
※ This cleaning mode will be accepted when the distance of the start and end position is less than 1 m.
The 2nd stage:
Pressing the 'Start' button will then make the Robot Cleaner clean the manually outlined area by itself.
※ Upon failure to correctly outline a zone, a voice will announce, which says "Area does not meet the specifi ed conditions. Please
continue to make specifi ed area for cleaning process."
Use the Remote Controller to assign a zone, again.
※ Upon completion of cleaning for all selected areas, the Robot Cleaner will be placed in the cleaning mode (Zigzag or Cell by Cell)
which was run, right before.
Tip
• While recharging, you cannot activate 'My Space clean' mode.
• To change the cleaning mode while Robot Cleaner is in operation, press 'Stop/OK' button first to select a mode
The cleaning will the start from the begining.
20
My Space