LG VR6260 Série Guide D'utilisation page 20

HOW TO CHARGE THE BATTERY
Remaining Battery Charge Indicator
Battery level is indicated on Status Display, as follows.
• If recharging is in progress, the Battery Level Lamp fl ickers.
• If recharging is complete, only the 'Battery' and 'Clean Mode' icons are displayed to save the energy.
• Upon the need for recharging, only the fi rst level of Battery Level Lamp will be on and fl ickering.
Charging is required
※ If Robot Cleaner goes back to Home Station, with a low level of battery while it is the
'Clean Mode' lamp starts to fl icker.
- When the 'Clean Mode' lamp starts to fl icker after recharging is complete, Robot
Cleaner will then resume cleaning the areas which were not covered.
- Pressing the 'Start' button on the Remote Controller or 'Stop' button on main unit
whilst it is recharging, with the 'Clean Mode' lamp fl ickering, will also make Robot
Cleaner fi nd and clean uncovered spots.
- Pressing the "Start" button on the remote control or the "Start/Stop" button on
the device after changing the mode will make the Robot Cleaner start to clean from
beginning again.
If the Battery is Not Charging
Check 1:
If the battery is not charging even when the Robot Cleaner is attached to
the home station, check the following items.
- Turn the power switch on the rear-left of the Robot Cleaner off once and
then on again.
- Check the power lamp of the home station.
- Wipe the terminal on the home station with a dry cloth. (p32)
18
Flickering Flickering
Middle
Low
High
The status indication lamp while the
robot is charged
(In spatial Zigzag mode)
In the case of no existing area to
be cleaned
In the case of an existing area to
be cleaned (Flickering)
Power lamp
Charge terminal