Cleaning The Dust Bin Fi Lter - LG VR6260 Série Guide D'utilisation

CLEANING THE DUST BIN FILTER
The Dust Bin Filter consists of a HEPA Filter and Sponge Filter.
Clean both the HEPA and Sponge fi lters as per the following sequence.
1. Pull the hook on the left of the HEPA Filter module on the
rear side of Dust Bin to separate the HEPA Filter and the
sponge.
2. Thoroughly clean out the fi ne dust particles on the HEPA Filter,
with a vacuum cleaner or cleaning brush.
※ Do NOT wash the HEPA Filter with water.
Its suction power will be reduced.
3. Use a cleaning brush to clean the Sponge Filter.
If using water to clean it, allow it to dry completely in the
shade before refi tting.
4. Assemble the HEPA and Sponge fi lters back onto the Filter
Cover as per the following sequence.
※ Fit the rectangular locator on the HEPA Filter into the
locating slot of the fi lter body.
※ Be careful not to incorrectly assemble HEPA and Sponge
Filter onto the Filter Cover.
Tip
• To preserve the performance of Robot Cleaner, clean the HEPA Filter at least once a week, with a brush or
vacuum cleaner.
• If you run Robot Cleaner, with the Filter Cover assembled onto Dust Bin and without no filters inserted, it may
involve dusts coming inside to cause a failure.
30