Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
30
5.3
INSTALLING COMBUSTIBLE BOARD
EN
THE SURFACE ABOVE THE APPLIANCE GETS VERY HOT. IF PROPER FINISHING MATERIALS ARE
SIDE
WALL
6" (152mm)
MIN. TO A
SIDE WALL
Joint Compound where required
Joint compounds such as Durabond 90 and tapes that are resilient to heat and cracking should be used when
taping and mudding seams.
Setting tiles and grouting
We recommend you use tiles with a dry butt joint to be installed using a two-part mortar with an acrylic latex
additive, such as Mapei Kerabond/Kerlastic, to allow for slight movement in the normal operation of the
appliance.
If grout is used between the tiles, a polymer-based grout, such as Mapei Ultracolour plus, is recommended.
Primer/Paint
For a painted surface, use a 100% acrylic latex primer and finish coat. Paints may discolour.
W415-1285 / F / 12.21.16
!
NOT USED, CRACKING CAN OCCUR.
BHD4ST
38 1/4"
45"
(97.2cm)
(114.3cm)
WARNING
43 1/4"
(109.9cm)
BHD4P
38 1/4"
(97.2cm)
6" (152mm)
MIN. TO A
SIDE WALL
Publicité
Chapitres
Table des Matières
