Installing Non-Combustible Board - Napoleon LHD45N Instructions D'installation Et D'opération

26

4.10 INSTALLING NON-COMBUSTIBLE BOARD

EN
A NON-COMBUSTIBLE FINISHING MATERIAL BORDER, SUCH AS BRICK, MARBLE, GRANITE, ETC.
IS REQUIRED. FINISHING WITH JUST NON-COMBUSTIBLE BOARD TO THE SIDES AND TOP OF THE
THE SURFACE ABOVE THE APPLIANCE GETS VERY HOT. IF PROPER FINISHING MATERIALS ARE
The 14" (355.8mm) above the appliance opening
must not be fi nished with any combustible materials.
NOTE: To minimize
joints, it may be best
to replace the supplied
non-combustible board
with a larger piece.
14"
(356mm)
Joint Compound where required
Joint compounds such as Durabond 90 and tapes that are resilient to heat and cracking should be used when
taping and mudding seams.
Setting tiles and grouting
If using tiles, we recommend you use tiles with a dry butt joint to be installed using a two-part mortar with an
acrylic latex additive, such as Mapei Kerabond/Kerlastic, to allow for slight movement in the normal operation
of the appliance.
If grout is used between the tiles, a polymer-based grout, such as Mapei Ultracolour plus, is recommended.
Primer/Paint
For a painted surface, use a 100% acrylic latex primer and fi nish coat. Light coloured paints may discolour.
W415-1335 / 06.27.14
WARNING
!
APPLIANCE IS NOT ALLOWED.
NOT USED, CRACKING CAN OCCUR.
It is not required to cover the entire surface with a
non-combustible decorative fi nishing material if using
a full sheet of non-combustible board where re-
quired. However, a minimum of one course of tile is
required to border the sides and top around the door
opening. The larger the tile size, the better.
SUPPLIED NON-
COMBUSTIBLE
BOARD
TO CEILING
TOP OF
OPENING