Installing Combustible Board - Napoleon Ascent Multiface Serie Manuel D'installation Et D'opération

10.7

installing combustible board

WARNING
!
• The surface above the appliance gets very hot. If proper finishing materials are not used, cracking can occur.
• Ensure clearances are maintained for surround removal, as it must lift off the appliance for maintenance.
SIDE
WALL
6" (152mm)
MIN. TO A
SIDE WALL
Joint Compound where required
Joint compounds such as Durabond 90 and tapes that are resilient to heat and cracking should be used when
taping and mudding seams.
Setting tiles and grouting
We recommend you use tiles with a dry butt joint to be installed using a two-part mortar with an acrylic latex
additive, such as Mapei Kerabond/Kerlastic, to allow for slight movement in the normal operation of the appliance.
If grout is used between the tiles, a polymer-based grout, such as Mapei Ultracolour plus, is recommended.
Primer/Paint
For a painted surface, use a 100% acrylic latex primer and finish coat. Paints may discolour.
BHD4ST
38 1/4"
45" (97.2cm)
(114.3cm)
finishing
BHD4P
38 1/4"
(97.2cm)
43 1/4"
(109.9cm)
6" (152mm)
MIN. TO A
SIDE WALL
W415-1285 / H / 08.07.18
EN
39