Installing Non-Combustible Board - Napoleon HDX35NT Instructions D'installation Et D'opération

Masquer les pouces Voir aussi pour HDX35NT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

26
5.1

INSTALLING NON-COMBUSTIBLE BOARD

EN
A NON-COMBUSTIBLE FINISHING MATERIAL BORDER, SUCH AS BRICK, MARBLE, GRANITE, ETC.
IS REQUIRED. FINISHING WITH JUST NON-COMBUSTIBLE BOARD TO THE SIDES AND TOP OF THE
THE SURFACE ABOVE THE APPLIANCE GETS VERY HOT. IF PROPER FINISHING MATERIALS ARE
With the frame assembly in place, use drywall screws to
install the non-combustible board sides (1) and center (2).
NON-COMBUSTBLE
BOARD REQUIRED
4 3/4"
[121mm]
Joint Compound where required
Joint compounds such as Durabond 90 and tapes that are resilient to heat and cracking should be used when
taping and mudding seams.
Setting tiles and grouting
We recommend you use tiles with a dry butt joint to be installed using a two-part mortar with an acrylic latex
additive, such as Mapei Kerabond/Kerlastic, to allow for slight movement in the normal operation of the
appliance.
If grout is used between the tiles, a polymer-based grout, such as Mapei Ultracolour plus, is recommended.
W415-1434 / 06.09.15
WARNING
!
APPLIANCE IS NOT ALLOWED.
NOT USED, CRACKING CAN OCCUR.
2
1
1
NOTE: Avoid joints or grout lines aligning
with non-combustible board seams.

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Hdx35ptHdx52pt-2

Table des Matières