Wiring Requirements - Napoleon BHD4N Série Instructions D'installation Et D'opération

7.2.1 WIRING REQUIREMENTS

It is necessary to hard wire this appliance.
Permanently framing the appliance with an enclosure, requires the appliance junction box to be hard wired.
This appliance must be electrically connected and grounded in accordance with local codes. In the absence
of local codes, use the current CSA C22.1 Canadian electrical code in Canada or the ANSI/NFPA national
electrical code in the United States.
This appliance comes equipped with a battery back-up. If this back-up is used, install 4AA batteries (not
supplied) into the holder and connect to the wire harness.
TRANSFORMER
BATTERY
HOUSING
(SUPPLIED IN
MANUAL BAGGIE)
DC SUPPLY
!
DO NOT WIRE 110 VOLTS TO THE VALVE OR WALL SWITCH
ACS/IPI
SWITCH
ON / OFF
SWITCH
IPI / CPI
ON / OFF
DISCONNECT THESE
CONNECTIONS TO THE
ON/OFF SWITCH AND
CONNECT TO AN
OPTIONAL THERMOSTAT.
WARNING
VALVE
GROUND
EYELET
GROUND
GREEN
ORANGE
VALVE
ELECTRONIC
IPI BOARD
DFC
69.7
W415-1285 / F / 12.21.16
43
EN