Information For The Installer - CTC EcoWater 300 Instructions D'installation Et D'entretien

Congratulations
Congratulations on the purchase of your new CTC
domestic hot water heat pump. You will with no doubt
be pleased with this quality product.To ensure the
best performance and safety from this product, we
recommend you to read the instructions carefully. These
instructions contain the information you need to install
and use your new heat pump.
The heat pump normally covers a family's need for hot
water throughout the year. CTC EcoWater is equipped
with a built in coil for additional heat from an external
boiler, solar panels, etc.

Information for the installer

This manual should be read carefully before installation.
It contains all information needed for the installation.
Consider standards and local regulations regarding
water installation before taking the product into use.
Special consideration must be taken to water qualities
with larger amounts of for example; limestone, ochre
and dirt particles.
With reservation for typing errors. Subject to alterations in design.
For your own reference
Fill in the information below. It may be useful if anything should happen
Product
Date of installation
Installer
Before the first start check that the system is filled
with water and has been vented. Confirm that all
connections are screwed tight.
At the first start, or when the tank has been emptied,
there must be an operating time of 8 to 10 hours at an
air temperature of 15 °C to reach a water temperature
of 45-55 °C.
Basic heating principle
The heat pump operates on the air to water principal;
i.e. the air is drawn through an evaporator and cooled.
In the compressor the thermal energy of the air is
transformed to a higher temperature and through a heat
exchanger transferred to the water in the boiler.
Manufacturing No.
Telephone No.
English
5
CTC EcoWater