Charge Battery; Used Batteries; Working With The Lawnmower - Grizzly ARM 4051 A Lion-Set Traduction De La Notice D'utilisation Originale

C D E F G
M N O P Q
W X Y Z
Switch off the device, pull the igni-
tion key (
blades to come to a stop. There is
a risk of personal injury.
1. To insert the battery (7) into the
2. To remove the battery (7) from

Charge battery

Allow a freshly charged battery
(7) to cool down for approx. 15
minutes before inserting it into the
battery charger (11).
1. Remove the battery (7) from the
2. Insert the battery (7) in the char-
3. Plug the battery charger (11)
4. When the battery is fully rechar-
5. Press the release button (
H I J
All manuals and user guides at all-guides.com
R S T
23) and wait for the
device, push the battery along
the guide rail into the device. It
locks into place audibly.
the device, press the release
button (
7b) on the battery
and pull the battery out.
appliance, as necessary.
ging compartment of the battery
charger (11). It will audibly snap
in.
into a mains outlet. The charg-
ing indicator lights up:
green LED flashes, red LED
lights up: Battery charging
green LED lights up:
Battery is charged
ged unplug the battery charger
(11) from the mains.
on the battery (7) and pull the
battery out of the battery char-
ger (11).

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Waste Disposal and
Environmental Protection").
Self-propulsion
Self-propulsion is switched on by
pressing the safety switch (19) on
the handle (1) and simultaneously
pulling the drive bracket (18) in the
direction of the handle (1) until it
clicks in. Then release the drive
bracket (18). The forward move-
ment of the self-propulsion ends
when you release the safety switch
(19). In order to stop self-propul-
sion without switching off the mo-
tor, release the safety switch (19)
slightly until the self-propulsion
decouples. Now press the safety
switch back on the handle (1)
again and proceed mowing without
self-propulsion.

Working with the Lawnmower

Regular mowing encourages increased fo-
7b) liation of the grass and kills off weeds at the
same time. Therefore, not only does each
mowing increase the density of the lawn, it
also produces an evenly resilient lawn.
The first cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
GB
37