Preparation For Storage - MSA PremAire CADET Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PREPARATION FOR STORAGE

Note: Do not force-dry the parts by placing them in a
heater or in direct sunlight. The rubber will deteriorate.
When the facepiece is thoroughly dry, store the facepiece
in the plastic bag that it was shipped in.
1. In general, only the facepiece requires cleaning and
disinfecting after each use. If the apparatus is soiled
or has dirt accumulation, use a sponge damp with
mild soap solution or use a soft/medium bristle brush
to remove deposits that may interfere with normal
operation.
a. Ensure the second stage regulator is free of water,
dirt, or debris.
2. Inspect the entire apparatus as you reassemble it.
Follow the Inspection Instructions.
3. Thoroughly dry the facepiece and regulator after
cleaning and disinfecting. The facepiece can trap
water, which could enter the regulator.
TAL 706 (L) Rev. 8 - 800810
STORAGE
STORAGE
DO NOT store the respirator near substances that can
attack respirator components, causing them to fail to
perform as designed.
The PremAire CADET Respirator must be stored in a cool,
dry place away from direct sunlight. Heat and sunlight will
shorten the life of rubber parts.
16

Publicité

Table des Matières
loading

Table des Matières