Device Features - Comelit 20090334 Manuel Technique

Warning
• Install the equipment by carefully following the instructions given by the manufacturer and in compliance with the standards in force.
• All the equipment must only be used for the purpose it was designed for. Comelit Group S.p.A. declines any responsibility for improper use of the apparatus, for any alterations
made by others for any reason or for the use of non-original accessories or materials.
• All the products comply with the requirements of Directive 2006/95/EC (which replaced Directive 73/23/EEC and subsequent amendments), as certifi ed by the CE mark they carry.
• Installation, mounting and assistance procedures for electrical devices must only be performed by specialised electricians.
• Cut off the power supply before carrying out any maintenance work.
Serial Bridge Art. 20090334
20090334
SERIAL BRIDGE
RESET
CAUTION!! If the device is connected to the home automation BUS power supply or the alarm control unit power supply, the - terminal must
be connected to the -12 terminal to balance the reference negatives.
Introduction
The Serial Bridge module makes it possible to communicate with the SimpleHome home automation BUS and the SimpleSafe anti-intrusion system.
It can be used as follows:
- weekly schedule programmer: it can send commands to outputs, zones, scenarios and thermostats within the system.
- in/out link management: links an alarm control panel event (area status or input status) to an event for transmission over the home automation BUS
(modules, zones, scenarios, etc...).
- rule management: programs 3-element rules with AND/OR functions between inputs, outputs or security/home automation timer in order to
generate an event.
- scenario management: can program scenarios which include procedures for transmission to the SimpleSafe security system and/or the SimpleHome
home automation system.
User setup and management must take place via the WEB interface.

Device features

The Serial Bridge is a Web Server device which, by means of a PC browser, tablet, smartphone, etc... is able to do the following without the
installation of any additional programs:
1 display/control 8 areas for a compatible alarm control unit.
2 display the status of the fi rst 80 wired inputs of a compatible control unit.
3 display the status of the fi rst 48 wireless inputs of a compatible control unit.
4 display/control 48 lights on the BUS.
5 display/control 24 sockets on the BUS.
6 display/control 24 timed or shutter outputs
7 display/control 24 analogue inputs, which may be:
• 20046707 modules confi gured as thermostat with temperature sensor connected.
• thermostats and temperature sensors on the BUS.
8 display 8 load modules by consumption/production.
9 control the 16 scenarios set on the device.
From the Serial Bridge it is possible to confi gure:
1 up to 32 timers.
2 up to 32 commands sent over the link between the alarm control unit and the SimpleSafe BUS.
3 up to 32 rules with 3 elements each.
4 up to 32 scenario commands with 20 elements each.
1
2
BUS
3
RS232 / 485
POWER / STATUS 4
5
1
Description of the Serial Bridge:
1 Connection terminals:
- +: 12/24 Vdc power supply from home automation BUS or alarm
control unit.
D: Simplehome BUS data terminal.
NC - NO - C: Voltage-free relay contacts.
I2: Status input 2.
K: Common status input.
I1: Status input 1.
5: Alarm control unit GND RS232.
3: Alarm control unit RX RS232.
2: Alarm control unit TX RS232.
+12 -12: Alarm serial port power supply terminals.
485 A/L+ - B/L -: Alarm supervisor connection terminals.
2 LED indicating data transmission over home automation BUS.
3 LED indicating data transmission to control units.
4 LED indicating operation:
• slow flashing: normal operation.
• quick flashing: Bootloader status.
5 Reset button.
11