Wiring The Products; 1- Wiring Recommendations; 2- Terminal Strips - Jay Electronique ISIS Notice Technique D'installation Et D'utilisation

7.3- Wiring the products

7.3.1- Wiring recommendations

• Use control components with integrated interference suppression system.
• Do not place cables of different classes side by side.
• A minimum space (20 cm) should be observed between the different classes:
- Classe 1 : Radio, antenna cable (case of an antenna extension),
- Classe 2 : Mains for power supply of various units,
- Classe 3 : Power control for motors, variable speed drive, etc...
Ideally, each cable class should be run through a cable path
specifi c to the cable. If only one cable path is available, the cables
of different classes should be separated as much as possible.

7.3.2- Terminal strips

If fl exible stranded wire is used, crimped terminations should be
used to avoid false contacts and short circuits.
To open the connection terminal strips:
- Vertically insert the screwdriver (fl at tip screwdriver
of 1.5 to 3 mm width) in the slot located opposite
the wire,
- Insert the wire,
- Remove the screwdriver.
Do not apply any lever movement to the
screwdriver as this can result in damage to
the terminal strip and the printed circuit on
the motherboard.
ISIS - 331260D
To avoid any risk of electrocution, do not open the
receiver or transceiver unit when powered up.
revision02
DE EN FR
- 83 -