Connecting The Transmitter/Transmitter Module; Testing The Products - Jay Electronique ISIS Notice Technique D'installation Et D'utilisation

5.3- Connecting the transmitter/transmitter module

The transmitter must be wired as shown in the drawing below :
DC
9...30Volts

5.4- Testing the products

Supply the transmitter and the receiver or transceivers.
• Transmitter ISE or transmitter modules from IST side :
- A self-test is performed (indicator lights i1 to i8 fl ash sequentially).
- The Va (power supply) and i2 (input No. 2 active) indicator lights
should come on; the Vb indicator light (radio transmission) should
fl ash.
• Receiver ISR or receiver modules from IST side :
- The R2 and RM relays should activate (indicator lights R2 and RM
come on).
- The V1 (power supply) and V3 (radio reception) indicator lights
should come on.
In the event of a malfunction, refer to the «Diagnostics and corrective
actions» section.
ISIS - 331260D
Va
Vb
i2
i1 i3 i4
Va
i2
Vb
SET
ID
ON
1 2 3 4 5 6 7 8
CONFIG
ON
- 1 2 3 4 5 6 7 8
+
A B
DC
+
-
revision02
i5 i6 i7 i8
C 1 2 3 4 5 6 7 8
DE EN FR
- 69 -