Radio Quality» Rm Relay; Synchronizing Transceivers Ist - Jay Electronique ISIS Notice Technique D'installation Et D'utilisation

4.5- «Radio quality» RM relay
To check the state of the radio link between transmitter ISE and
receiver ISR or between two transceivers IST, an output «Radio
quality» is available on the receiver ISR or transceiver IST (relay
«RM»).
RM relay activated : ...... radio link between transmitter and
RM relay deactivated : .. no radio link between transmitter and
This function is only valid in «continuous transmission»
Note :
mode or «intermittent transmission» mode as soon an
input is active.

4.6- Synchronizing transceivers IST

When the installation includes transceivers IST, they must be
«Synchronized». «Synchronization» is performed on only one of
the two transceivers with the cursor nb.8 of the transmitter module
CONFIG DIP switch.
- Cursor Nb.8 of the
fi rst transceiver must
be on ON position
(active sync)
- Cursor Nb.8 of the
second transceiver
must be on OFF
position (inactive
sync)
ISIS - 331260D
receiver is good
receiver
Transmitter
module
IST_1
Receiver
module
IST_1
Transceiver
IST_1
revision02
CONFIG
ON
1 2 3 4 5 6 7 8
= cursor position
Transceiver
DE EN
CONFIG
ON
1 2 3 4 5 6 7
= cursor position
Receiver
module
IST_2
Transmitter
module
IST_2
IST_2
FR
- 67 -
8